VisionStat Plus MA-BCKS-7.0 Instrukcja Użytkownika Pobierz pdf (Strona 8)

Mobile Awareness

Installation: Monitor and Wiring Harness (Continued)

Before applying power to the system; make any Camera and trigger wire connections.

The 22-pin wiring harness’ wiring connections can be seen in the chart below. The

RCA connectors can be used to connect a second Monitor to the system for secondary

viewing.

White 4-pin Male Connection Camera/Channel 1

Blue 4-pin Male Connection Camera/Channel 2

Brown 4-pin Male Connection Camera/Channel 3

Green 4-pin Male Connection Camera/Channel 4

Red Wire +12-32VDC

Black Wire Ground

White Trigger Wire Trigger Wire for Channel 1

Blue Trigger Wire Trigger Wire for Channel 2

Brown Trigger Wire Trigger Wire for Channel 3

Green Trigger Wire Trigger Wire for Channel 4

Yellow RCA Video Output

White RCA Audio Output

The trigger wires can be used to achieve hands free operation for the VisionStat

system. For example, wiring the BLUE Trigger Wire to your right turn signal will

automatically toggle the Monitor to Channel 2 once the BLUE Trigger Wire receives

+12VDC. Once power is removed from the trigger wire, in this case the turn signal

being turned off, the Monitor will revert to the previous channel being displayed.

The most common use of the trigger wires, along with the turn signals, is using the

BROWN Trigger Wire to toggle the Monitor to Channel 3 to view the rear back up

Camera while in reverse, typically wiring it to the reverse lights. Keep in mind, the

desired Camera must be connected to the corresponding color.

Fig 8: 22 Pin Wiring Harness

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

VisionStat Plus MA-BCKS-7.0 Instrukcja Użytkownika Strona 8